GIC Protocol converter, Modbus TCP, Din rail, screw, 72mm
Subcribe to back in stock notification
Performing the function of converting the protocols of one device to make it suitable for another device, the state-of-the-art GIC Protocol Converters help attain interoperability efficiently and seamlessly.
- Serial protocol support for Modbus (RTU and ASCII) Master/Slave
- Network protocol support for Modbus TCP (Server/Client)
- Supports Raw Serial to Ethernet conversion with Telnet RFC2217
- Serial Interface support for RS232, RS422 and RS485 network
- Serial Baud rate: 300 bps to 115.2 Kbps
- Ethernet interface support: 10/100Mbps with Auto Negotiation
- Configurable using Embedded Web server and Application software
- Network Protocols: ARP, TCP/IP, HTTP, BOOTP, TFTP, ICMP, TELNET, DHCP, AutoIP
- Isolation between Communication Ports & Input Power supply
Parameters
Supply voltage: 12 - 240V DC
Supply variation: -10% to +25%
Power consumption (Max.): 2 W
Protocol conversion: Modbus RTU / ASCII to Modbus TCP
Operation mode: Modbus RTU / ASCII (Master / Slave), Modbus TCP (Server / Client)
Configuration management: HTTP Web Server and Application software
Serial interface
Number of serial ports: 1
Serial interface: Port1: Screw terminals for RS232, RS422 and RS485 interface
Signals: RS232 : RXD, TXD, GND
Serial Interface Selection:
For Port1: Mode selection using RST switch with Mode LED indication
Serial communication parameters:
- Baud Rate: 300bps to 115.2Kbps
- Data Bits: 7,8 ; Flow Control : None
- Parity:Odd, Even, None
- Stop Bits: 1,2
Fail safe resistor: 4K7 Resistor Pull up ( TX+) & Pull Down (TX-) on BUS
Terminating resistor: Connect externally if required
Isolation: Isolation 2 KVrms
LAN interface
Port: RJ45, Ethernet 10/100 Mbps
LAN isolation: 1.5KVrms magnetic Isolation
Network protocol’s supported: Standard Protocols used :
HTTP, DHCP, AutoIP, UPnP, TCP, UDP, IP, ARP, ICMP, Protocols used for firmware updating : BOOTP, TFTP
Isolation: 1.5KVrms magnetic Isolation
Feature: Mapping and Background Processing Data Block (BPD)
Configuration software: Windows Based Software to Configure Ports as well as Selection of Protocol Driver
Reset: Front Panel recessed, Loads Default Factory Settings & Serial Mode selection
LED indications: Serial TX and RX, LAN: LINK and Activity, Power ON, Error, Mode Selection Indication LED
Operating temperature: 0°C to + 55°C
Enclosure: Flame Retardant UL94-V0
Dimension (W x H x D): 72 X 90 X 58mm
Weight (unpacked): 185 g
Mounting: Base / DIN Rail